...
The delivery package includes support brackets for rack installation and mounting screws to fix the device case on the brackets. To install the support brackets:
Figure 60 75 – Support brackets mounting
...
- Attach the device to the vertical guides of the rack.
- Align mounting holes in the support bracket with the corresponding holes in the rack guides. Use the holes of the same level on both sides of the guides to ensure the device horizontal installation.
- Use a screwdriver to screw the router to the rack.
Figure 62 76 – Device rack installation
...
To install and connect to vESR, go to the vESR documentation section.
Scroll Pagebreak |
---|
ESR-1000, ESR-1200, ESR-1500, ESR-1511, ESR-1700, ESR-3100, ESR-3200, WLC-3200 power module installation
ESR-1000/1200/1500/1511/1700/3100/3200 routers and WLC-3200 controller can operate with one or two power modules. The second power module installation is necessary when the device operates under strict reliability requirements.
From the electric point of view, both places for power module installation are identical. In the context of device operation, the power module can be in the main and reserve slot. For information on priority see table 'Description of connectors, LEDs and controls located on router'. Power modules can be inserted and removed without powering the device off. When additional power module is inserted or removed, the router continues operation without reboot.
Figure 63 77 – Power module installation
Figure 64 78 – Plug installation
Предупреждение |
---|
Power module fault indication may be caused not only by the module failure, but also by the absence of the primary power supply. |
...
1. Insert the top SFP module into a slot with its open side down, and the bottom SFP module with its open side up.
Figure 65 79 – SFP transceivers installation
2. Push the module into the device housing until it is secured with a clicking sound.
Figure 66 80 – Installed SFP transceivers
...
1. Flip the module handle to unlock the latch.
Figure 67 81 – Opening SFP transceiver latch
2. Remove the module from the slot.
Figure 68 82 – SFP transceivers removal