...
- MAC Address – MAC address of the unregistered access point;
- Status – operating status of the access point;
- IP Address – IP address of the unregistered access point;
- Board Type – model of the unregistered access point;
- SW Version – firmware version of the unregistered access point;
- HW Version – hardware version of the device;
- Serial Number – serial number of the device set by the factory.
Scroll Pagebreak
Submenu "Configuration Warnings"
...
| Примечание |
|---|
If an airtune profile is added to a location, some parameters of the AP radio interfaces in that location will be controlled by airtune (if airtune is also enabled globally on the "General settings" page). Accordingly, when airtune is enabled in a location, it is not reasonable to change parameters related to power and radio channels in the radio profiles of that location, as they will not be applied on the AP because these parameters are automatically configured through airtune. If you want to change the channel width or channel list for auto-selection on the APs, you must first disable airtune, apply the changes, and then re-enable airtune to automatically manage the channels according to the new settings. |
Scroll Pagebreak
The table contains the basic settings for each profile, such as:
...
- 36, 40, 44, 48 – for 5 GHz.
Scroll Pagebreak
Possible values:
- 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13 – for 2.4 GHz;
...