...
Attach the bracket to the device with the screws provided, as shown in the figure below.
Install the device on communications mast/pole with Ethernet port down as it is shown in the figure below. Attach the device using clamps supplied in the device package. Follow the safety rules and recommendations given in Safety rules and Installation recommendations.
- Remove the cover that closes the Ethernet port on the bottom panel of the device. Ground the device using a grounding connector (for H/W version: 1v5 and higher), then connect the Ethernet cable to the PoE port. When building a network over fiber, install the transceiver and make the connection.
- Close the bottom cover.
- Connect the antenna to the device using the cable assemblies.
- Adjust the position of the antenna so that subscriber devices fall into the coverage area of the installed antenna.
- Connect the Ethernet cable coming from WOP-2ac-LR5 to the PoE port or the injector or switch (IEEE 802.3at-2009).
- If you use a PoE injector, connect it to 220 V power supply network using the cable.
- Adjust the antenna more precisely using light indicators on the device.
...