Для этого необходимо воспользоваться командой:
console# show fiber-ports optical-
...
transceiver detailed interface
...
{
...
gigabitethernet
...
gi_port
...
| tengigabitethernet
...
te_port}
...
Пример:
...
console# show fiber-ports optical-transceiver detailed interface
...
TengigabitEthernet 0/
...
1
Port Temp Voltage Current Output Input LOS Transceiver
...
Port Temp Voltage Current Output Input LOS Transceiver
[C] [V]
...
[mA]
...
Power Power Type
[mW / dBm]
...
[mW / dBm]
...
----------- ------ ------- -------- ------------- -------------- ---- -------------
...
te1/0/
...
1 29 3.
...
31 3.57 0.
...
50 / -
...
3.
...
00 0.
...
50 / -
...
2.96 No Fiber
Temp - Internally measured transceiver temperature
...
Voltage - Internally measured supply voltage
...
Current - Measured TX bias current
Output
...
Power - Measured TX output power in milliWatts/dBm
Input
...
Power - Measured RX received power in milliWatts/dBm
...
LOS - Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
Transceiver information:
Vendor name:
...
FANG HANG
Serial number:
...
A85371140603
Part number: FH-SP851TCDL03
Vendor revision: V02
Connector type: LC
Type: SFP/SFP+
Compliance code:
...
10GBASE-
...
SR
Laser wavelength:
...
850 nm
Transfer distance:
...
80 m
Diagnostic: supported
Примечание: на коммутаторах 23хх, 33хх и т.д. с версией 4.0.х команда имеет вид
show fiber-ports optical-transceiver interface {gigabitethernet gi_port | tengigabitethernet te_port}
Threshold parameters:
Temperature [C]
Low Warning: -35 High Warning: 95
Low Alarm: -40 High Alarm: 100
Voltage [V]
Low Warning: 2.90 High Warning: 3.50
Low Alarm: 2.80 High Alarm: 3.60
Current [mA]
Low Warning: 2.00 High Warning: 13.00
Low Alarm: 1.00 High Alarm: 15.00
Output Power [mW / dBm]
Low Warning: 0.19 / -7.00 High Warning: 1.00 / 0.00
Low Alarm: 0.15 / -8.00 High Alarm: 1.25 / 0.99
Input Power [mW / dBm]
Low Warning: 0.05 / -13.00 High Warning: 1.00 / 0.00
Low Alarm: 0.02 / -16.00 High Alarm: 1.99 / 3.00