Для этого необходимо воспользоваться командой:
show fiber-ports optical-transceiver detailed interface {gigabitethernet gi_port | tengigabitethernet te_port}
Пример:
show fiber-ports optical-transceiver detailed interface TengigabitEthernet 0/1
Port Temp Voltage Current Output Input LOS Transceiver
[C] [V] [mA] Power Power Type
[mW / dBm] [mW / dBm]
----------- ------ ------- -------- ------------- -------------- ---- -------------
te1/0/1 29 3.31 3.57 0.50 / -3.00 0.50 / -2.96 No Fiber
Temp - Internally measured transceiver temperature
Voltage - Internally measured supply voltage
Current - Measured TX bias current
Output Power - Measured TX output power in milliWatts/dBm
Input Power - Measured RX received power in milliWatts/dBm
LOS - Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
Transceiver information:
Vendor name: FANG HANG
Serial number: A85371140603
Part number: FH-SP851TCDL03
Vendor revision: V02
Connector type: LC
Type: SFP/SFP+
Compliance code: 10GBASE-SR
Laser wavelength: 850 nm
Transfer distance: 80 m
Diagnostic: supported
Threshold parameters:
Temperature [C]
Low Warning: -35 High Warning: 95
Low Alarm: -40 High Alarm: 100
Voltage [V]
Low Warning: 2.90 High Warning: 3.50
Low Alarm: 2.80 High Alarm: 3.60
Current [mA]
Low Warning: 2.00 High Warning: 13.00
Low Alarm: 1.00 High Alarm: 15.00
Output Power [mW / dBm]
Low Warning: 0.19 / -7.00 High Warning: 1.00 / 0.00
Low Alarm: 0.15 / -8.00 High Alarm: 1.25 / 0.99
Input Power [mW / dBm]
Low Warning: 0.05 / -13.00 High Warning: 1.00 / 0.00
Low Alarm: 0.02 / -16.00 High Alarm: 1.99 / 3.00