Pre-starting procedures

It is recommended to reset the device to factory settings when switching it on for the first time. Use display menu and buttons to reset the device — implement the following:

Menu -> 3. Settings -> 2. System -> 5. Reset settings -> Yes

The device will automatically reload.

To start the operation, you should connect the device to PC via LAN interface. Use a web browser:

1. Open web browser, i.e Firefox, Opera, Chrome.

2. Enter the device IP address in the browser address bar.

By default, IP phone receives an IP address and other network parameters via DHCP.

To get an obtained IP address, implement Menu -> 1. Status -> 1. Network using display menu.

When the device is successfully detected, username and password request page will be shown in the browser window:

By default, username — admin, password — password

3. Enter your username into 'Login' field and password into 'Password' field.
4. Click 'Log in' button. Monitoring panel will be shown in the browser.

Before you start, please, update the software. See section «Firmware upgrade» submenu.

You may download the up-to-date firmware version on the Downloads page or contact Eltex technical support. You may find contacts on TECHNICAL SUPPORT page.

Web interface description

Web interface operation modes

Web interface of the VP-12(P) device can operate in two modes:

Configuration — a system mode which enables full device configuration. The mode has three tabs: Network, VoIP and System.
Monitoring — system monitoring mode — allows you to view various device operation information: Internet connection activity, phone port status, amount of received/sent data via network interfaces, etc.

Key elements of web interface

User interface window is divided into 6 areas (see figure "Key elements of web interface"):

1. User name for log in, session termination button in the web interface ('Sign Out') for the current user and dropped down menu for changing language.

2. Menu tabs allow you to select configuration and monitoring categories: Network, VoIP, System , Monitoring.

3. Submenu tabs allow you to control settings field.

4. Device settings field based on the user selection; allows you to view device settings and enter configuration data.

5. Configuration management buttons. For detailed description see Applying configuration .

- Apply — apply and save the current configuration into flash memory of the the device;
- Discard — discard changes (effective only until 'Apply' button is clicked).

6. Informational field showing firmware version and web interface version.

Main elements of web configurator

Applying configuration

«Apply» button appears as follows: . Click it to save the configuration into the device flash memory and apply new settings. All settings will be accepted without device restart.

See the following table for detailed information on web interface visual indication of the status of settings application process:

Visual indication of the current status of the setting application process

Appearance	Status description
	When you click the 'Accept' button, settings will be applied and stored into the device memory. This is indicated by the icon in the tab name and on the 'Apply' button.
	Successful settings saving and application are indicated by icon in the tab name.
	If the parameter value being specified contains an error, you will see a message with the reason description and icon will appear in the tab name, when you click 'Apply' button.