Для этого необходимо воспользоваться командой:
show fiber-ports optical-transceiver detailed interface {gigabitethernet gi_port | tengigabitethernet te_port}
Пример
show fiber-ports optical-transceiver detailed interface TengigabitEthernet 0/1
Port Temp Voltage Current Output Input LOS Transceiver
[C] [V] [mA] Power Power Type
[mW / dBm] [mW / dBm]
----------- ------ ------- -------- ------------- -------------- ---- -------------
te1/0/1 35 3.37 15.78 0.25 / -6.00 0.20 / -6.79 N/S Fiber
Temp - Internally measured transceiver temperature
Voltage - Internally measured supply voltage
Current - Measured TX bias current
Output Power - Measured TX output power in milliWatts/dBm
Input Power - Measured RX received power in milliWatts/dBm
LOS - Loss of signal
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
Transceiver information:
Vendor name: OEM
Serial number: S1253261240356
Part number: FH-SB5312CDL20
Vendor revision: A0
Connector type: LC
Type: SFP/SFP+
Compliance code: unknown
Laser wavelength: 1550 nm
Transfer distance: 20000 m
Diagnostic: supported
Threshold parameters:
Temperature [C]
Low Warning: -35 High Warning: 95
Low Alarm: -40 High Alarm: 100
Voltage [V]
Low Warning: 2.90 High Warning: 3.50
Low Alarm: 2.80 High Alarm: 3.60
Current [mA]
Low Warning: 2.00 High Warning: 70.00
Low Alarm: 1.00 High Alarm: 80.00
Output Power [mW / dBm]
Low Warning: 0.12 / -9.00 High Warning: 0.50 / -3.00
Low Alarm: 0.10 / -10.00 High Alarm: 0.63 / -2.00
Input Power [mW / dBm]
Low Warning: 0.00 / -23.98 High Warning: 1.00 / 0.00
Low Alarm: 0.00 / -26.99 High Alarm: 1.99 / 3.00