stack upgrade-enable
This command enables the automatic firmware update for the 'slave' module in the stack.
The use of the negative form (no) of the command disables the automatic firmware update for the 'slave' module in the stack.
Syntax
[no] stack upgrade-enable
Parameters
The command contains no arguments.
Command mode
CONFIG
Example
ma4000(config)# stack upgrade-enable
stack sync-allow
This command sets permission for synchronization of configuration files in the stack between current devices.
The use of the negative form (no) of the command prohibits synchronization of configuration files in the stack between current devices.
Syntax
[no] stack sync-allow
Parameters
The command contains no arguments.
Command mode
ROOT
Example
ma4000# stack sync-allow
Set permission for synchronization of configuration files.
show stack
This command is used to view the state of the stack, the booted firmware version, and permissions for synchronization of configuration between modules in the stack.
Syntax
show stack
Parameters
The command contains no arguments.
Command mode
ROOT
Example
ma4000# show stack Stack Units ~~~~~~~~~~~ Unit Position Role Prio MAC Address Version ---- -------- ------ ---- ----------------- --------------- *1 Left MASTER 240 a8:f9:4b:88:33:a0 1 3 2 333 40586 Synchronization state in the stack: Unknown Stack-channel State ~~~~~~~~~~~~~~~~~~~ Interface Status -------------------- -------------------- stack-port 1/0 down (on discovery) stack-port 1/1 down (on discovery)